PL1220 Owner’s Manual
61
1. Connect the PC to the laser machine via USB cable.
2. On RDWorks, click “File” and click “vendor settings”.
3. Enter the vendor password: RD8888
4. Click the “Read” button to read machine settings.
5. Click the “Save” button to save machine settings
6. On RDWorks, click “Config” and click “system settings”.
7. Select the “System Info” tab.
8. Click the “Read” button to read system settings.
9. On RDWorks, click “Config” and select “Page Settings”.
10. Click the “Read” button to read page settings.
7.4.1 Troubleshooting
Table 8-5: RDWorksV8 Troubleshooting
Problem(s) Solution(s)
Cannot connect or communication error
Verify the laser machine is powered on and
functional. Use a hardwired USB to USB
connection if the Ethernet method is
problematic.
To Next Page
