PL1220 Owner’s Manual
63
8.1.1 Adjustment Procedures
1. Unscrew the height adjustment clamp.
2. Adjust the height of the laser tube such that the focused beam is in contact with the work
surface.
a. This can be achieved by setting the focal spacing to a distance between 7mm and 9
mm.
3. The focal spacing will depend on the process and the material but it is generally between
7mm and 9 mm.
WARNING
NEVER use the laser machine without the focal lens in place.
The maximum cut depth depends on the material. Always test
the operation prior to running a work file.
To Next Page
Loading...
