SmartShop|Maker Owner’s Manual
43
Error Code Potential Issue(s) Resolution(s)
Fatal low memory, memory
space is less than 100K
Users design too many texts and
pictures when they design CE
human-machine interface and
make the capacity of system
memory less than 100k.
Human-machine interface of
controller should simplify
components, only design
effective variables and
scripts to avoid the low
memory phenomenon.
The number of interpolation
loss times is bigger than 100
1. Axis card is damaged.
2. System resource is exhausted.
3. The setting of interpolation
time interval (Pr3203) is too
small.
1. Replace the hardware of
axis card.
2. Replace a better
motherboard.
3. Set longer interpolation time
interval.
Axis Group setting error
Parameter setting error.
Ex: Assume the machine exists
XYZ axes, each associated
axis group is set as follows:
Pr701 = Pr702 = Pr703
=5(XYZ axes belong to the 1
st
group + 3
rd
group)
Suppose that Pr731 = 3(axis
groups in CNC are the 1
st
spindle group the 2
nd
spindle
group, and the 3
rd
spindle
group). It means that the 2
nd
axis group is not covered by an
axes and one alarm will
appear.
Please check the matching
between Pr701 ~ Pr716 and
Pr731.
To Next Page
Loading...
