Laguna Tools SmartShop Maker - Page 46

SmartShop|Maker Owner’s Manual
46
Error Code Potential Issue(s) Resolution(s)
Machine date file write fail
many times, re-calibrate
before machining
1. CF card may be seriously
damaged and CF card should
be processed soon.
2. Registry.dat or registry.mir file
is set to read-only.
3. System file cannot handle
resource well, lead to writing
file unsuccessfully.
1. Scan CF card.
2. Check whether the
machining setting is correct.
3. Reboot.
Machine data file fault error,
re-calibrate before machining
and do scandisk
1. CF card may be seriously
damaged and CF card should
be processed soon.
2. Registry.dat or registry.mir file
is set to read-only.
3. System file cannot handle
resource well, lead to writing
file unsuccessfully.
1. Scan CF card.
2. Check whether the
machining setting is correct.
3. Reboot.
A,B feedback signal error
When servo type is set EMP2,
internal axis card will automatically
detect the A, B encoder signals, if
signal error or have A-phase
signal, but no B-phase signal, this
alarm will appear.
Check the servo cable or
replace the axis card.
Error counter overflow
When servo type is set 0(EMP2),
4(PMC4), 5(SERVO6), internal
axis card will automatically detect
the A, B encoder signals, if signal
error or too much input signal,
counter overflow will appear.
Check the servo cable or
replace the axis card.