Laguna Tools SmartShop Maker - Page 64

SmartShop|Maker Owner’s Manual
64
Error Code Potential Issue(s) Resolution(s)
P address must be integer Programming error
Change P address into an
integer.
Dot angle and axis command
conflict
Programming error Check the machining program.
Inc. axis command and abs.
axis command conflict
Programming error
Decide to use incremental or
absolute command and enter
the correct command.
Arc center vector and radius
conflict
Programming error Check the machining program.
Metric/Inch cmd. not available
under quiet mode
Programming error
Please check the machining
program.
Corner round and chamfer
cmd. conflict
Program error
Do not let chamfer command
and fillet command exist in the
same line.
Invalid G Code Program error Enter the valid G-Code.
No main program assignment The program is not loaded. Specify the main program.
Threading block feedrate
exceed
Program error
Decrease the cutting speed of
threading.
Tapping block feedrate
exceed
Program error
Decrease the cutting speed of
tapping.
Overcut by tool radius too big Tool compensation causes overcut
Check the machining program to
decide whether this part of the
machining cancels radius
compensation.
Exact stop wait timeout Servo vibration
1. Servo tuning.
2. Change parameters.