SmartShop|Maker Owner’s Manual
65
Error Code Potential Issue(s) Resolution(s)
G04 dwell time cannot be
negative
Program error
Check the machining program
and enter a positive value to
G04.
Part program file does not
exist
Ensure the program file exists.
Communication link failure
Reconnect a good
communication link.
Loading page size too small
Contact with the machinery
manufacturer.
File size too large Program error
Reduce the program size or split
program into two (2)
subprograms.
File content is empty
Loading program error or CF card
damaged
Reload program or replace CF
card.
Loading page lock failure
Contact machinery
manufacturers.
Sequence number not found Program error
Use sequence number in the
program range.
Cannot use jump statement in
sequential file
Do not use jump command to
execute sequential file.
To Next Page
Loading...
