Lakeshore 340 - 9.3 IEEE-488;SERIAL INTERFACE COMMANDS

Lake Shore Model 340 Temperature Controller User’s Manual
Remote Operation 9-21
9.3 IEEE-488/SERIAL INTERFACE COMMANDS
The IEEE-488/Serial Interface command list that follows is grouped by function with the most often used
commands listed first. The actual list of commands is presented in alphabetical order. Parameter conventions
used in the command list are as follows:
<??? enable> A parameter with enable as part of the name can use these values: 0 (disabled) or 1
(enable).
<??? status> A parameter with status as part of the name can use these values: 0 (off or disabled) and 1
(on or enabled).
<??? value> A parameter with value as part of the name is specified in floating point format. This format
can use scientific notation. Example: -2.45600E+3.
<bit weighting> A number between 0 and 255 derived from the sum of all the weighted bit values.
Bit Weight
0 1
1 2
2 4
3 8
4 16
5 32
6 64
7 128
<input> Indicates which sensor input to use. Sample values are: A, B, and A3.
<loop> Indicates which control loop to use. Valid values are: 1 - 2.
<off/on> Indicates whether an item is turned off or turned on. 0 is off and 1 is on.
<output> Indicates which analog output to use. Valid values are: 1 - 2.