Lamtec VMS Series User Manual

106
8 System Operation
Fault
Code
No.
Restart according to Description
TRD EN676
904 1 1 Error in reference of firing rate
Ü Fault during an internal self-test.
Reset the fault; switch the mains voltage off and on again if necessary.
Check all fuses in the device.
If fault messages are constantly appearing one after the other  exchange the
device or respective card.
Using the device enter the Setting mode for about 3 seconds and then return to the
Automatic mode to reimport the reference voltage.
The potentiometer possibly has the incorrect polarity, is incorrectly connected (cen-
tre pick-up mixed up with the outer one), or is defective.
905 1 1 Error in reference element of main processor
Ü Fault during an internal self-test.
Reset the fault; switch the mains voltage off and on again if necessary.
Check all fuses in the device.
If fault messages are constantly appearing one after the other  exchange the
device or respective card.
906 1 1 Error in reference element of monitoring processor
H Fault during an internal self-test.
Reset the fault; switch the mains voltage off and on again if necessary.
Check all fuses in the device.
If fault messages are constantly appearing one after the other  exchange the
device or respective card.
907 1 1 Curve set adjustment via LAMTEC SYSTEM BUS, selftest recognizes fault
911 1 1 Error in reference, channel: 1
Ü Fault during an internal self-test.
Reset the fault; switch the mains voltage off and on again if necessary.
Check all fuses in the device.
If fault messages are constantly appearing one after the other  exchange the
device or respective card.
Using the device enter the Setting mode for about 3 seconds and then return to the
Automatic mode to reimport the reference voltage.
The potentiometer possibly has the incorrect polarity, is incorrectly connected (cen-
tre pick-up mixed up with the outer one), or is defective.
912 1 1 Error in reference, channel: 2
Ü See S911
913 1 1 Error in reference, channel: 3
Ü See S911
914 1 1 Error in reference, channel: 4
Ü See S911
915 1 1 Fault in reference, duct: 5
Ü See S911

Lamtec VMS Series Specifications

General

Brand	Lamtec
Model	VMS Series
Category	Control Systems
Language	English