9. Use one permissible (textile) round sling, chain, steel cable or similar
for each ring bolt. Attach the round slings securely to the crossbeam.
10. Align the round slings parallel to one another and at right angles to the
top of the device. The crossbeam È must be parallel with the top of
the device.
An inclined arrangement of the round slings is not permitted.
Use a crossbeam.
11. Use a crane to lift the device o the transport pallet.
Table 2: Standard accessories Integral T
Device type Designation Quantity Catalog number
All devices Operating manual 1 Q4DA-E_13-006
All devices Mains cable 1 ---
IN 130 T, IN 230 T(W) Ring bolt M10 x 17 2 DSS 044
IN 530 T(W), IN 1030 T,
IN 1330 TW
Ring bolt M10 x 17 (higher load capacity) 2 DSS 085
IN 130 T to IN 530 TW Hose fitting for pump connector 2 EOA 004
IN 1030 T to IN 1330 TW Union nut for pump connector 2 EOV 197
IN 1030 T to IN 1330 TW Hose nozzle for pump connector 2 HKA 168
All devices Hose nozzle with union nut for drain nozzle 1 EOA 078
Water-cooled devices Hose fitting for cooling water nozzle 2 EOA 001
Fig. 4: Lift device
V6 Integral Process Thermostats and High-Temperature Thermostats 19 / 198