Lauda IN 130 T - Before starting up; Install device

4 Before starting up
4.1 Install device
WARNING!
Rolling away or overturning of the device due to incorrect han-
dling
Impact, crushing
 Do not tilt the device.
 Position the device on an even, non-slip surface with a
sucient load carrying capacity.
 Actuate the castor brake when setting up the device.
 Do not place heavy parts on the device.
WARNING!
Degradation of overflow or drain
Electric shock
 Overflow hose and drainage hose must each slope down-
ward separately all the way into a collecting vessel.
WARNING!
Danger of overpressure from high ambient temperature
Injury, escape of refrigerant
 Note the permitted ambient temperature.
CAUTION!
Risk of heat transfer liquid escaping
Scalding, cold burns
 The temperature and media resistance of the hoses used for
the device overflow must be suitable for the application.
Installation conditions:
n Irritant vapors may develop, depending on the heat transfer liquid and
operating temperature used. Always ensure that the vapors are ade-
quately extracted.
n Note the electromagnetic compatibility (EMC) requirements of the
device Ä Chapter 1.3 “EMC requirements” on page 10.
n Do not cover the ventilation openings of the device.
n Further conditions for installation apply to the devices. These are speci-
fied in the technical data Ä Chapter 15.1 “General data” on page 161.
V6Integral Process Thermostats and High-Temperature Thermostats34 / 198