6300 Rev H User’s Manual
125-9106A Page 14
Down-Arrow – Used to jog a target-value down or move to previous profile-point..
Further details are provided in Section 3.
Center section: This section of the keypad is used for numeric entry. To enter a negative value, enter the
value and then press the ‘+/-‘ key. Use the ‘000’ key to enter three consecutive zeroes, which is especially
useful when entering numbers in thousands.
Right section: This section has the ‘GO’ and ‘CANC’ keys which are used to either execute or exit/cancel a
command. The CANC key is also used to acknowledge messages.
The Power key, indicated by the symbol , is used to either turn-On or turn-Off the 6300.
When the Remote unit is Off and the Ready LED is On, pressing the Power key for 2 to 3 seconds will turn-
On the 6300. The display takes another 2 seconds to come on. The Power key may be held down until the
display turns On (a total of about 4 seconds), but must be released within 2 to 3 seconds after the display
turns On (to avoid going into the Power-Off cycle).
When the Remote unit is On, pressing the Power key for 3 seconds will turn the 6300 and the Remote unit
Off. After the unit turns Off, the Power key must be released within 2 to 3 seconds, to avoid going into the
Power-On cycle.
[3] Connector:
This circular connector is used to connect the Remote unit to the Main unit through the Remote cable. The
Remote unit must not be disconnected from the Main unit while the unit is operating. This will cause the
unit to turn Off.
[4] Tilt-stand:
On the rear of the Remote unit, a tilt-stand has been provided which allows the Remote to be tilted to a
convenient viewing angle.
To Next Page
Loading...