6300 Rev H User’s Manual
125-9106A Page 59
4.4 LOADING PROFILES
1. Connect the one-to-one RS232 cable to the RS232 port on the top panel of the 6300. You will need
to remove the access panel for this. Connect the other end of this cable to the COM1 port on your
PC. If you are using a USB port on the PC, then connect through the USB to RS232 converter
provided with the unit.
2. Setup the 6300 for loading profiles, as shown in Section 3.10.5.
3. Start the 6300 file in Hyperterminal. On the task bar select “Transfer”. Then select “Send Text
file”. The dialog box will open that allows you to select the .txt file you want to transfer. Open
this file. You will see the profile being loaded as it is echoed back from the 6300.
4. After the profile has completed loading, the last section should say “PASS”. If it does not then
the profile did not load correctly. If no characters are echoed when you open the .txt file to
transfer (load), then you probably have a communication problem.
5. If you see “garbage” on the first line of the profile as it loads then you should redo the load. This
could happen on some systems on the very first profile you load during a session in
Hyperterminal.
6. To load more profiles in the same session simply repeat step 3 from the point you select
“Transfer”. After all profiles you wish to load have been transferred, press GO on the 6300.
Check that the profile loaded properly by selecting Function 4 on the 6300 and entering the
profile number starting at step 1 (i.e. “15.1” to check profile 15). Step through the profile using
only the Up-Arrow key and check if the points match what you have setup on the PC as your
profile.
4.5 RUNNING A PROFILE
Details on how to Run a profile are provided in Section 3.10.4
To Next Page
Loading...