MPC2810 Motion Controller Hardware Manual
37
Files\MPC2810\Demo\VCDemo\VCDemo3. It is used for testing commands and
I/Os of MPC2810. Modules are built in VCDemo3 to process DXF file, 2D
trajectory motion can be generated with this program. Display resolution:
1024*768 (Recommend).
4.2 How to use the debugging program
After running VcDemo3.exe, five modules will present as fig. 4-2. They are
Continuous Trajectory, PTP Control, IO Test, Commands Test and Parameters
Setting
Fig. 4-2 Test Program
(1). Continuous Trajectory Module
This module is the default one after running the program. The button
could be applied to switch from other module.
Continuous
Trajectory
PTP Control IO Test
Commands
Test
To Next Page
Loading...
