MPC2810 Motion Controller Hardware Manual
V
card should be connected to the Breakout board first, then the motors and
drives to the Breakout board. To disconnect the system correctly and
securely, make sure to turn off the external power supply first.
Disconnect the motors and motor drives from the Breakout board, and
then disconnect the control cards from the Breakout board.
Do not operate if there are suspicions of potential errors. If you suspect
any parts of the Product are damaged, please have them inspected by
qualified technicians.
Do not subject the Product to water, corrosive or flammable gases, and
combustibles.
Keep the Product from dust and humidity.
Prevent the Product from ESD damage. Do not touch the electronic
components on the control cards. Do not place the control cards on
surfaces possible to have ESD impacts on the Product. Place the control
cards in ESD-proof bags or packages.
To Next Page
Loading...
Need help?
General
