LEGRAND Wattstopper LMCP48 - Schedules and Holidays

20
Panel Programming
The majority of programming functions for panels are found under the Panel Programming menu. This includes:
• Schedules – Allows you to specify an event and assign it to a group
• Holidays – Allows you to specify a specific date as a holiday. Used in conjunction with schedules.
• Dark/Light –
• Groups – Allows you to specify groups and assign loads to the groups
• Occupancy Sensors – Allows you to configure how loads respond to triggers from occupancy sensors.
Display Description Press
Location Settings
Date and Time
Network
Button Binding
Panel Programming
Status
Panel Setup
From Panel Setup, scroll to Panel Programming.
Press Select.
then
Select
603981210
Schedules
Holidays
Dark/Light
Groups
Occupancy Sensors
Panel Programming
The Panel Programming screen is displayed
To avoid repeating the same steps for every function described in the following pages, the Panel Programming Sections assume you
have already navigated to the Panel Programming screen.
Schedules
On this set of screens, you assign and event to a group, and set one action for that event. For each event, you specify the time the
event occurs. You also specify whether the event will occur on a per day basis. Additionally, you specify whether the event will occur on
any day designated as a holiday.
Display Description Press
603981210
Schedules
Holidays
Dark/Light
Groups
Occupancy Sensors
Panel Programming
From the Panel Programming screen, highlight
Schedules and press Select
Se
lect
Point to the desired
Panel IR Sensor and
press ‘Select’
Point the LMCT-100 at the infrared sensor on
the LMRD board and press Select to open the
Program Schedule screen.
Se
lect
Event Number: <1>
Type: <Normal Hours>
Time: <07>:<00>
Group: <1>
Program Schedule
ACTIVE DAYS
DONE DELETE SEND
Select the Event Number in which to store the
schedule information. The Type determines the
action for the event. For details on the actions, see
the Schedules on page 7. Set the Time for the
event to occur and assign the event to a Group.
Then, highlight ACTIVE DAYS and press Select.
then choose
ACTIVE DAYS
and press Select
or
to move to each
parameter
or
to change the value
of the parameter
Mon: <Y> Tue: <Y>
Wed: <Y> Thu: <Y>
Fri: <Y> Sat: <N>
Sun: <N> Holiday: <N>
Schedule Active On
DONE
For each day of the week, select whether the
event will be active (Yes or No). Additionally, select
whether the event will be active on holidays. (You
determine which days are holidays in the Holidays
screen.)
Highlight DONE and press Select to return to the
Program Schedule screen.
then choose
DONE and
press Select
or
to move to each
parameter
or
to change the value
of the parameter