Leica RM2245 - Page 19

17
Leica RM2245
6
5
4.3 Unpacking and installation (cont.)
Fig. 10
7
8
9
• Takeoutthefixingmodule(5). To do so,
hold it by the top edge of the module and
in the recessed grip (6) and pull it out by
pulling upwards.
• Lift the instrument*(7) by holding it by
the base plate at the front and under the
instrument on the back and lift it out of the
formed cushion (8).
• Placetheinstrumentonastablelabora-
tory table.
The two sliding elements (9) located on
the rear of the base plate make it easier
to move the instrument on the table.
• Tomovetheinstrument,holditbythefront
of the base plate, lift it up gently and slide
it on its slides.
4. Instrument Setup
• (*=theinstrumentillustrationisprovidedas
an example only.)
Never hold the instrument for
transport by the handwheel or the
rotary knob for section thickness
adjustment.
Observe the correct resting angle
to the table to avoid pinching your
fingers.