5.4303.8558.0 -
Maintenance 7-11
Replace a metal Strip
Make sure that strips recessed in the floor are installed flush with the
floor level or slightly above the floor level. Do not install strips below the
floor level.
Figure 29. Metal strip holes
KEY:
A: Round hole
B: Slotted hole
C: Slotted hole
If a metal strip sticks out over the edge of a concrete plate (2x2 m) the
swivel wheel of the machine will deform the metal strip and the screws
will brake due to the tension.
Figure 30. Metal strip positioning (1)
KEY: 1. Metal strip - 2. Concrete plate
1. Remove all screws of the strip.
in n o vato rs in agriculture
To Next Page
Loading...
