Figure 76. Removal of an M.2 boot drive
Step 3. (Optional) If necessary, remove the M.2 heat sink and the M.2 drive from the tray.
a.
Press the tabs on the M.2 and heat sink tray to disengage the heat sink.
Note: If necessary, press the tabs with a flat-head screwdriver.
b.
Lift the M.2 heat sink out of the tray.
c.
Slide the M.2 drive outward and remove it from the tray.
Figure 77. Removal of the M.2 heat sink
After this task is completed
• If necessary, peel off the thermal pad from the M.2 drive or M.2 heat sink.
• Install a replacement unit (see
“Install an M.2 boot drive” on page 106).
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Chapter 5. Hardware replacement procedures 105
To Next Page
Loading...
