Figure 80. Installation of an M.2 heat sink to the M.2 tray
Step 4. Install the M.2 drive with heat sink onto the I/O module board.
a.
Insert the M.2 drive at an angle to the connector.
b.
Lower down the other side of the M.2 drive; then, gently press the M.2 drive down into
place.
c.
Tighten the screw.
Figure 81. Installation of an M.2 boot drive
After this task is completed
• Install the drive cage and connect all the cables (see
“Install a drive cage” on page 86).
• Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 161).
Demo video
https://www.youtube.com/watch?v=ewzFpHEFV7M
108
ThinkEdge SE350 V2 User Guide
To Next Page
Loading...
