Figure 78. Boot M.2 slots
1 Boot M.2 slot 1 2 Boot M.2 slot 2
Step 2. (Optional) If necessary, install the M.2 drive into the M.2 tray.
a.
Peel off the plastic liner from the thermal pad in the tray.
b.
Slide the M.2 drive all the way into the tray, the side with the most chips facing up. Make
sure that the screw cutout of the drive is aligned with the cutout of the tray.
Figure 79. Installation of a thermal pad and M.2 drive to the tray
Step 3. (Optional) If applicable, install the M.2 heat sink into tray.
a.
Peel off the plastic liner from the thermal pad at the bottom side of the heat sink.
b.
Align the heat sink with the four clips of the tray; then, insert and press down the heat sink
until it clicks into place.
Chapter 5. Hardware replacement procedures 107
To Next Page
Loading...
