Figure 83. Removal of a memory module
After this task is completed
• If necessary, install a replacement memory module to the empty slot (see
“Install a memory module” on
page 111
).
• If you are instructed to return the component, follow all of the packaging instructions and use any
packaging materials for shipping that are supplied to you.
Demo video
https://www.youtube.com/watch?v=5rGMVURgZXQ
Install a memory module
Follow instructions in this section to install a memory module.
About this task
See
“Memory module installation rules and order” on page 41 for detailed information about memory
configuration and setup.
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Chapter 5. Hardware replacement procedures 111
To Next Page
Loading...
