Lenovo ThinkEdge SE350 V2 - Troubleshooting by symptom

Figure 132. Front operator panel LEDs
Table 18. Front operator panel LEDs
1 & 8 “System ID button with system ID LED (blue)” on
page 188
4 & 5 “Power button with power status LED (green)” on
page 189
2 & 7 (Reserved)
9 “NMI button” on page 189
3 & 6 “System Error LED (yellow)” on page 188
1 8 System ID button with system ID LED (blue)
Use this system ID button and the blue system ID LED to visually locate the server. Each time you press the
system ID button, the state of the system ID LED changes. The LED can be changed to on, blinking, or off.
You can also use the Lenovo XClarity Controller or a remote management program to change the state of the
system ID LED to assist in visually locating the server among other servers.
• On: System is identified. Press the button once to turn on the LED. Pressing the button a second time will
make the LED blink. Pressing it a third time will turn off this LED.
• OFF: System is not identified.
3 6 System Error LED (yellow)
When this yellow LED is on, it indicates that one or more system errors have occurred.
188
ThinkEdge SE350 V2 User Guide