CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
• R006
CAUTION:
Do not place any object on top of a rack-mounted device unless that rack-mounted device is
intended for use as a shelf.
Attention:
• Read
“Installation Guidelines” on page 37 and “Safety inspection checklist” on page 38 to make sure that
you work safely.
• To remove a node from the rack:
1.
“Remove the shipping bracket from the enclosure” on page 46
2. “(Optional) Remove the enclosure from the rack” on page 47
3. “Remove a node from the enclosure” on page 50
Remove the shipping bracket from the enclosure
Follow instructions in this section to remove the shipping bracket from the enclosure.
Notes:
• Depending on the specific configuration, the node, enclosure, or rails might look different from the
illustrations in this section.
• For details of the rail options for the rack installation, see
“ Rail Installation Guides” on page 215.
Procedure
Step 1. Remove the seven screws of the shipping bracket as shown.
Figure 19. Removal of the shipping bracket screws
Step 2. Pull the shipping bracket away from the enclosure.
46
ThinkEdge SE350 V2 User Guide
To Next Page
Loading...
