Demo video
https://www.youtube.com/watch?v=huDZmqU6pHQ
Remove the drive cage
Follow instructions in this section to remove the drive cage from the node.
About this task
To avoid potential danger, make sure to read and follow the safety information.
• S002
CAUTION:
The power-control button on the device and the power switch on the power supply do not turn off
the electrical current supplied to the device. The device also might have more than one power cord.
To remove all electrical current from the device, ensure that all power cords are disconnected from
the power source.
Attention:
• Read
“Installation Guidelines” on page 37 and “Safety inspection checklist” on page 38 to make sure that
you work safely.
• Remove the shipping bracket, if applicable (see
“Configuration guide” on page 45); then, power off the
server and disconnect the power cords (see
“Power off the server” on page 44).
• Remove the node from the enclosure , if applicable (see
“Configuration guide” on page 45); then, carefully
lay the node on a flat, static-protective surface.
Note: Depending on the specific configuration, the drives, drive bay fillers, or drive cage might look different
from the illustrations in this section.
Procedure
Step 1. Make preparations for this task.
a. Remove all drives and drive bay fillers (see
“Remove a hot-swap drive” on page 78) and
disconnect all cables.
b. If applicable, unlock or remove any locking device that secures the top cover, such as a
Kensington lock; then, remove the top cover (see
“Remove the top cover” on page 158).
c. Disconnect all the cables from the drive backplane(s) (see
“Cable routing for the hot-swap
drives” on page 165
).
Step 2. Disengage and remove the drive cage.
a. Remove the four screws as shown to disengage the drive cage.
80
ThinkEdge SE350 V2 User Guide
To Next Page
Loading...
