6.Pressdownthesmallhandleonthemicroprocessorsocket,andthenpullthehandlealittlebitoutward
toreleaseitfromthesecuredposition.Then,gentlypressthemicroprocessorretainertoopenit.Ensure
thatthesmallhandleandthemicroprocessorretainerareinthefullyopenposition.
Figure62.Openingthehandleandmicroprocessorretainer
7.Touchthestatic-protectivepackagethatcontainsthenewmicroprocessortoanyunpaintedsurfaceon
theoutsideoftheserver.Then,removethenewmicroprocessorfromthepackage.
Chapter6.Installing,removing,orreplacinghardware115
To Next Page
Loading...
