Figure 71. Removal of the PCIe riser assembly
Step 3. If necessary, disconnect all the PCIe riser cables from the system board (see “PCIe riser cable
routing” on page 177
); then, lay the PCIe riser assembly on a flat, static-protective surface.
After this task is completed
1. To replace a PCIe adapter, see
“Remove a PCIe adapter” on page 118 and “Install a PCIe adapter” on
page 119
.
2. If necessary, replace or remove the PCIe riser card from the riser cage.
Chapter 5. Hardware replacement procedures 117
To Next Page
Loading...
