Notes:
• When removing the node, note the node tray number and make sure to install the node in
the same tray from which it was removed. Reinstalling the node into a different tray requires
the node to be reconfigured.
• For safety, make sure to hold the node with both hands when lifting the node.
c. Remove the top cover (see
“Remove the top cover” on page 168).
d. If the GPU air duct is installed in the node, remove it (see
“Remove the GPU air duct” on page
91
).
e. Remove the PCIe riser assembly from the node and, if necessary, disconnect the PCIe cables
from the system board (see
“Remove the PCIe riser assembly” on page 116 and “PCIe riser
cable routing” on page 177
).
Step 2. Remove the PCIe adapter from the PCIe riser cage.
a.
Remove the screw that secures the PCIe adapter to the PCIe riser.
b.
Grasp the PCIe adapter by its edges and carefully pull it out of the PCIe slot.
Figure 73. Removal of a PCIe adapter
After this task is completed
1. Install a replacement unit or filler (see “Install a PCIe adapter” on page 119).
2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a PCIe adapter
Follow instructions in this section to install a PCIe adapter.
About this task
To avoid potential danger, make sure to read and follow the safety information.
Attention:
Chapter 5. Hardware replacement procedures 119
To Next Page
Loading...
