Figure 102. Installation of a 1U Standard PHM for two-processor configuration
Figure 103. Installation of a 1U Performance PHM for two-processor configuration
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see “Install the top cover” on page 170).
2. Reinstall the node into the chassis (see
“Install a node to the chassis” on page 75).
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
“Install a hot-swap power supply” on page 61 and “Power on the node” on page
51
.)
4. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
Chapter 5. Hardware replacement procedures 147
To Next Page
Loading...
