Lenovo ThinkSystem SD530 V3 - Page 32

Figure 2. Front view of the ThinkSystem SD530 V3 node
Table 9. Components in the front view of the ThinkSystem SD530 V3 node
1 E3.S drive bay
6 External diagnostic handset connector
2 Drive activity LED
7 Front operator panel buttons and LEDs
3 Drive status LED
8 USB 3.2 Gen 1 (5 Gbps) connector
4 Pull-out information tab
9 VGA connector
5 Serial connector
1 E3.S drive bays
• Install E3.S drives or drive fillers to these bays (see
“Hot-swap drive replacement” on page 94).
• For more information about the drive LEDs, see
“Drive LEDs” on page 205.
2 & 3 Drive activity LED & Drive status LED
For more information about the drive activity and status LEDs, see
“Drive LEDs” on page 205.
4 Pull-out information tab
This tab contains below information:
• Network information such as MAC address and XCC network access label.
• Drive bay numbers.
For more information about this tab, see
“Identify the system and access the Lenovo XClarity Controller” on
page 35
.
5 Serial connector
Connect a 9-pin serial device to this connector.
6 External diagnostic handset connector
Connect the external diagnostics handset to this connector.
For more details, see “External Diagnostics Handset” on page 210.
7 Front operator panel buttons and LEDs
For more information about the front operator panel buttons and LEDs, see
“Front operator panel LEDs” on
page 205.
22
ThinkSystem SD530 V3 User Guide