Figure 28. Installation of the chassis midplane
After this task is completed
1. Reinstall the PSU cage to the chassis (see “Install a PSU cage” on page 70).
2. Install the chassis to the rack (see
“Install the chassis to the rack” on page 54).
3. Reinstall the nodes into the chassis (see
“Install a node to the chassis” on page 75).
4. Reinstall each PSU slot with a PSU or PSU filler (see
“Install a hot-swap power supply” on page 61 and
Installation of a PSU filler).
5. Proceed to complete the parts replacement (see
“Complete the parts replacement” on page 171).
Install a PSU cage
Follow instructions in this section to install a PSU cage.
About this task
To avoid potential danger, make sure to read and follow the safety information.
70 ThinkSystem SD530 V3 User Guide
To Next Page
Loading...
