A video of this procedure is available at YouTube: https://www.youtube.com/playlist?list=PLYV5R7hVcs-
AU3iY3F7lq3qfqr5caGbIu
.
Procedure
Step 1. If the optical drive bay shield is installed on the front bezel, remove it from the front bezel. To
remove the front bezel, see “Remove the front bezel” on page 51.
a.
Press the release tab on top of the drive bay shield.
b. Rotate the drive bay shield and remove it from the front bezel.
Figure 56. Removing the optical drive bay shield
Step 2. (Optional) Install the optical drive retainer.
a.
Align the pin on the bottom of the retainer and the corresponding slot on the optical drive,
then insert the pin into the slot.
b.
Insert the rest two pins on retainer to the corresponding slots on the optical drive.
Figure 57. Installing the retainer to the optical drive
74 ThinkSystem ST50 V2 Setup Guide
To Next Page
Loading...
