Step 3. (Optional) Align the optical drive bezel with the slots on the optical drive; then, insert the bezel into
the optical drive.
Figure 58. Installing the optical drive bezel
Step 4. Install the optical drive.
a.
From outside of the chassis, insert the optical drive into the chassis.
b.
Slide the optical drive inward until the latch snaps into place.
Figure 59. Installing the optical drive
Step 5. Connect the signal and power cable to the system board, see “Internal cable routing” on page 19.
Remove the optical drive cage
Follow this procedure to remove the optical drive cage.
Chapter 3. Server hardware setup 75
To Next Page
Loading...
