7
Commissioning
Using the keypad XT EMZ9371BC − Parameter setting
EDK82EV113 DE/EN/FR 8.1
L
130
Function keys
) Note!
Press the key combinations with :
and keep them pressed, then additionally press the second key.
Press key
Function −31−
Menu level Code level Parameter level Operation level
Change to the parameter
level
Change to the operation
level
Change to the code level
Load predefined
configurations in the menu
"Short setup"
1)
Accept parameter, if SHPRG
or SHPRG is displayed
Change between menu
points
Change code number
Change number above
cursor
Change quickly between
menu points
Change code quickly
Change number above
cursor quickly
Change between main menu, submenus and code level
Cursor to the right
Cursor to the left
Cancel function of key the LED in the key disappears
Inhibit the controller, LED in the key lights up
Reset fault (TRIP−Reset): 1. Remove cause of malfunction
2.
press
3.
press
1)
only active when operating with the basic device series 8200 vector or 8200 motec
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
