Lenze 8200 vector - Page 133

7
Commissioning
Using the keypad XT EMZ9371BC − Parameter setting
EDK82EV113 DE/EN/FR 8.1
L
132
Menu structure
Main menu Submenus
Description
No. Display No. Display
1 USER menu Defined codes in C0517
2 Code list All available codes
2.1 ALL All available codes in ascending order (C0001 ... C7999)
2.2 Para set 1 Codes in parameter set 1 (C0001 ... C1999)
2.3 Para set 2 Codes in parameter set 2 (C2001 ... C3999)
2.4 Para set 3 Codes in parameter set 3 (C4001 ... C5999)
2.5 Para set 4 Codes in parameter set 4 (C6001 ... C7999)
3 Remote para See description of the keypad Remote parameter setting
Only active with function module system bus (CAN)
4 Quick start Quick commissioning of standard applications
4.1 Keypad quick Function check
Linear V/f−characteristic control
Frequency setpoint via keypad
4.2 V/f quick Linear V/f−characteristic control
Frequency setpoint selectable analogically via potentiometer, fixed
setpoints (JOG) selectable via terminal
4.3 VectorCtrl qu Vector control
Frequency setpoint selectable analogically via potentiometer, fixed
setpoints (JOG) selectable via terminal
5 Short setup See description of the keypad Quick configuration of predefined applications
6 Diagnostic Diagnostics
6.1 Fault history Error analysis with history buffer
6.2 Status words Display of status words
6.3 Monit drive Display codes in order to monitor drive
6.4 Monit FIF Display codes in order to monitor a field bus function module
7 Param managm Parameter set management
7.1 Load/Store Parameter set transfer, restore delivery status
7.2 Copy PAR1 −>2 Copy parameter set 1 into parameter set 2
7.3 Copy PAR1 −>3 Copy parameter set 1 into parameter set 3
7.4 Copy PAR1 −>4 Copy parameter set 1 into parameter set 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com