Lenze E82ZAFPC201 - Safety Instructions; Device- and Application-Specific Safety Instructions; Residual Hazards

Safety instructions
Device− and application−specific safety instructions
2
l
10
EDS82ZAFPC201 EN 4.0
2.2 Device− and application−specific safety instructions
ƒ During operation, the function module must be firmly connected to the standard
device.
ƒ With external voltage supply, always use a separate power supply unit, safely
separated to EN 61800−5−1 ("SELV"/"PELV"), in every control cabinet.
ƒ Only use cables corresponding to the given specifications (¶ 22).
, Documentation for the standard device, control system, system/machine
All other measures prescribed in this documentation must also be
implemented. Observe the safety instructions and application notes stated in
the documentation.
2.3 Residual hazards
Protection of persons
ƒ If the controllers are used on a phase earthed mains with a rated mains voltage
³ 400 V, protection against accidental contact is not ensured without implementing
external measures. (See chapter "4.3", ^ 15)
Device protection
ƒ The module contains electronic components that can be damaged or destroyed by
electrostatic discharge.