Lenze PROFINET 9400 - Page 87

Lenze · E94AYCER communication module (PROFINET®) · Communication Manual · DMS 11.0 EN · 04/2016 · TD17 87
13 Error messages
13.2 Possible causes and remedies
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
PROFINET: Internal error [0x00c86100]
PROFINET: Internal error [0x00c86101]
PROFINET: Internal mapping error [0x00c86110]
PROFINET: Invalid parameter set [0x00c8641f]
PROFINET: Error: Lenze setting loaded [0x00c86420]
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Send communication module together with a
description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Internal error Send communication module together with a
description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The selected PDO mapping is invalid:
• An object not supporting the required properties has
been specified.
• More than 64 bytes of data have been mapped.
Repeat PDO mapping
( 55).
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
No active parameter set could be loaded. Download application again (including module)
If this happens repeatedly, send the communication
module together with a description of the fault to Lenze.
Response (Lenze setting printed in bold) Setting: not possible
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The access to a parameter set in the memory module via
the Servo Drive 9400 was not successful.
Download application again (including module)
If this happens repeatedly, send the communication
module together with a description of the fault to Lenze.