Lenze SMVector - Page 50

45 CMVETH01B
Cyclic Data Access
Fault Codes
Fault Number Display Fault Description
16 F.cF Incompatibility Fault
17 F.F1 EEPROM Hardware Failure
18 F.F2 Edge Over Run; Soft Intr Re-entry
19 F.F3 PWM Over Run
20 F.F5 Stack Over Voltage Fault
21 F.F5 Stack Under Voltage Fault
22 F.F6 BGD Missing Fault
23 F.F7 Watchdog Timed Out Fault
24 F.F8 Illegal OPCO Fault
25 F.F9 Illegal Address Fault
26 F.bF Drive Hardware Fault
27 F.F12 AD Offset Fault
28 F.JF RKPD Lost Fault
29 F.AL Assertion Level switched during Operation Fault
30 F.F4 FGD Missing Fault
31 F.F0 PW Missing Fault
32 F.FOL Follower Loss
33 F.F11 Internal Communication from JK1 Lost Fault
34 F.ntF Module Communication (SPI) Timeout Fault
35 F.fnr FNR (Invalid Message Received)Fault
36 F.nF1 Network Fault #1
37 F.nF2 Network Fault #2
38 F.nF3 Network Fault #3
39 F.nF4 Network Fault #4
40 F.nF5 Network Fault #5
41 F.nF6 Network Fault #6
42 F.nF7 Network Fault #7
43 F.nF8 Network Fault #8
44 F.nF9 Network Fault #9
46 - 50 RESERVED
5.7.6.8 P45x = 8, Digital I/O Status
The Digital I/O Status Word consists of 16 control bits some of which are reserved.
Table 20: Digital I/O Status Word
b15 b14 b13 b12 b11 b10 b9 b8
Reserved Reserved Reserved Reserved Reserved Relay
Active
TB14
Output Active
TB13C
Input Active
b7 b6 b5 b4 b3 b2 b1 b0
TB13B
Input Active
TB13A
Input Active
Reserved TB1
Active
Reserved Reserved Reserved Reserved