Lenze SX-1 - Variable and Position Jump Instructions

lFCvv = aaaa Uww
lFCvv < aaaa Uww
lFCvv > aaaa Uww
Meaning:
Jump to Subroutine Uww (adr. ww), it the value of Counter Cvv is equal to (=), less than
(<) or greater than (>) the value aaaa.
Number ot Subroutine U: ww = 0 ... 99
NumberotCounterC: vv = 0...99
Reterence Value: aaaa = - 9999 to + 9999
IF > vvvvv.vvv Luu
lF <vvvvv.vvv Luu
Meaning:
Jump to Label Luu (Address uu), it the Position Value vvvvv.vvv is greater than (»or less
than (<) the Actual position.
NumberotLabelL: uu = 0...99
Position Value: vvvvv.vvv = -99999.999 ... +99999.999.
NOTE:
PA These instructions may not be used if Parameter P29
PA V selects Relative (endless) positioning mode.
PA C
PA vvvvv.vvv
Meaning: Move to absolute position vvvvv.vvv.
Value: vvvvv.vvv = -99999.999 ... +99999.999
This position instruction refers to the home (zero) position of the machine.
NOTE:
lt two absolute position instructions with the same value follow each other, the second
instruction causes no turther motion.
Example: PA 1000.000
PA 1000.000 .~— no effect
____ __ _________— 8/6
Lenze