Leuze electronic BPS 34 - Page 86

Device parameters and interfaces
Leuze electronic BPS 34 85
TNT 35/7-24V
Note!
The movement status is displayed for speeds from 0.01m/s.
Attention!
The "Dynamic preset" module (module 4), the "MVS label" function and the "error tolerance
time" can be used to activate the
… messages of the input data. Depending on the con-
figuration, these may be normal states.
Output data
None
Speed limit
value
status 4
Signals whether the current
speed is compared with this
limit value.
1.4 Bit
0: Comparison not active
1: Comparison active
0 –25a
Dyn. speed
limit value
status
Signals whether the current
speed is compared with this
limit value.
1.5 Bit
0: Comparison not active
1: Comparison active
0 –26a
Input data length: 2 byte
l
m
g
a
f