Leuze electronic BPS 34 - Page 90

Device parameters and interfaces
Leuze electronic BPS 34 89
TNT 35/7-24V
Hex coding of module 25 "Static speed limit values"
The value listed in the table shows the hex coding of the default settings.
Input data
None
Output data
None
8.1.7.27 Module 26: Dynamic speed limit value
Note!
Underlined in the CR column are the modules which must be activated in addition to the cur-
rent module.
Parameter length: 50 byte
Internal address of module 25 Speed limit value mode address 0 Direction selection address 0 Switching type address 1 Speed limit value 1 address 2 Speed hysteresis 1 address 4 Range start limit value 1 address 6 Range end limit value 1 address 10
1B 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Speed limit value 2 address 14 Speed hysteresis 2 address 16 Range start limit value 2 address 18 Range end limit value 2 address 22 Speed limit value 3 address 26 Speed hysteresis 3 address 28 Range start limit value 3 address 30 Range end limit value 3 address 34
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Speed limit value 4 address 38 Speed hysteresis 4 address 40 Range start limit value 4 address 42 Range end limit value 4 address 46
00 00 00 00 00 00 00 00 00 00 00 00