5
MPEG4/MJPEG, when pressed and released (less then 3
seconds), WCS-0020 will be in the WPS PBC mode (Auto
link mode).
• WPS Pin Code Mode. For the Wireless IP Camera with
MPEG4/MJPEG, when pressed and held for over 3
seconds, WCS-0020 will be in the WPS Pin Code mode.
• Reset to manufacturer default value and reboot. When
pressed and held over 10 seconds, the settings of FCS-
0020/WCS-0020 will be set to their default values.
Note:
After this procedure is completed, the Power LED will blink
three times to confirm that the reset was completed
successfully.
Package Contents
The following items should be included: If any of these items are damaged or missing,
please contact your dealer immediately.
1. FCS-0020/WCS-0020
2. Power adapter
3. Antenna (WCS-0020 only)
4. Camera Stand
5. CD Manual/Utility
6. Quick Installation Guide
To Next Page
Loading...
