LevelOne FCS-0020 - Chapter 5 Web-Based Management; Introduction; Connecting to FCS-0020;WCS-0020

27
Chapter 5
Web-based Management
This Chapter provides Setup details of the FCS-0020/WCS-0020’s
Web-based Interface. This Chapter is for the Camera Administrator
only.
Introduction
The FCS-0020/WCS-0020 can be configured using your Web Browser. The FCS-
0020/WCS-0020 must have an IP address which is compatible with your PC.
The recommended method to ensure this is to use the supplied Camera Wizard, as
described in Chapter 2 - Basic Setup.
Connecting to FCS-0020/WCS-0020
• If using only your Web Browser, use the following procedure to establish a
connection from your PC to the FCS-0020/WCS-0020:
• Once connected, you can add the FCS-0020/WCS-0020 to your Browser's
Favorites or Bookmarks.
Connecting using your Web Browser
1. Use the Camera Wizard to get the IP address of the FCS-0020/WCS-0020.
2. Start your WEB browser.
3. In the Address box, enter "HTTP://" and the IP Address of the FCS-0020/WCS-
0020.
4. You will then be prompted for a username and password.
• If using the default values, enter administrator for the name, and leave the
password blank.
• Otherwise, enter the Administrator ID and Administrator Password set on the
Maintenance screen.
5