LevelOne WAB-3003 - Panel Function Description

User’s Manual
WAB-3003 108M 11g Outdoor PoE CPE/ AP/ Bridge
6
2.2 Panel Function Description
WAB-3003
Power Red LED ON indicated Power on, and OFF indicates
power off
1
2~3 Wireless Signal Strength For showing the signal strength situation (2:Yellow;
3:Green)
WLAN Green LED ON indicates system ready 4
5 Wireless Signal Strength For Showing the signal strength situation
Ethernet Green LED ON indicates connection, OFF indicates no
connection, and BLINKING indicates transmitting data
6
7 RJ-45 PoE Connector For connecting to the Power Sourcing Equipment(PSE)
8 N-type Connector For connecting to an antenna
9 Reset Button * (Screw) For testing the system of AP
Reset Procedure
Make sure the WAB-3003 completes booting and is already running
(The booting process of system usually takes 2 minutes)
Unscrew the screw then you will see the reset button (inside the hole)
Use the provided reset pin to press and hold the reset button for 15 seconds
Release the reset button and leave the system re-booting for 2minutes