User’s Manual
WAB-3003 108M 11g Outdoor PoE CPE/ AP/ Bridge
88
5.2.1 General Settings
This section is for configuring the system RF settings.
Band: Select an appropriate wireless band: 802.11b, 802.11g or mixed mode 802.11b+802.11g,
or select Disable if the function is not required.
ESSID: The ESSID (Service Set ID) of the client device that the system is to be associated with.
Super G: Options of Bursting, Fast Frames, and Atheros’ featured Dynamic Turbo can be
selected to boost wireless throughput.
Short Preamble: The short preamble with a 56-bit synchronization field can improve WLAN
transmission efficiency. Select Enable to use Short Preamble or Disable to use Long Preamble
with a 128-bit synchronization field.
Max Transmit Rate: The maximum wireless transmitting rate. Select the desired rate from the
drop-down list box. The system uses the highest possible rate when Auto is selected.
Transmit Power: The signal strength transmitted from the system. Select among Auto, Lowest,
Low, Medium, High, and Highest from the drop-down list box.
ACK Timeout: When packet loss is increasing over longer distance, ACK Timeout can be used to
alleviate this issue.
To Next Page
Loading...
