User’s Manual
WAB-3003 108M 11g Outdoor PoE CPE/ AP/ Bridge
13
3.2.2 Quick Configuration
WAB-3003 is a dual-mode system which can be configured as either an access point (AP Mode) or
a gateway (CPE Mode) based on deployment needs. This section provides a step-by-step
configuration procedure for installing CPE mode and AP mode respectively.
< AP Mode – Default Mode>
Step 1
: Mode Confirmation
Ensure that the Operating Mode is currently at AP mode.
Click on the Status button and then select the System Overview tab. The Operating Mode is
at the System section on the System Overview page.
Note:
For more information on switching to AP mode, if it is not currently active, please refer to AP
Mode Section 4.1.2 Operating Mode.
To Next Page
Loading...
