so that you may select a clean channel for your device based on the scan result. Open “Site Survey”
in “Tools” as below.
Figure 42 Site Survey Tool
Ping Watch Dog
If the link is somehow broken and cut off your ability the log in to the unit, the ping watchdog has a
chance to reboot due to loss of connectivity.
Figure 43 Ping Watchdog
Ping Watchdog
Enable Ping Watchdog: To activate ping watchdog, check this checkbox.
IP Address to Ping: Specify the IP address of the remote unit to ping.
Ping Interval: Specify the interval time to ping the remote unit.
Startup Delay: Specify the startup delay time to prevent reboot before the CPE is fully initialized.
Failure Count To Reboot: If the ping timeout packets reached the value, the CPE will reboot
automatically.
To Next Page
Loading...
