5-9
System Controls
Dump
Press Options to
select MIDI transmit
speed. Press Options
again to exit.
This control is provided for recording changes in a sequence, or for control of one
or more additional MPX G2s. Select On to have values resulting from front panel
operations sent out as System Exclusive messages.
Options: Automation Xmit ID
Press Options to access the Automation Xmit ID screen where you can select
0-126 to identify the target MPX G2s.
This control is provided for communication with one or more additional MPX G2s,
or computer editor software. On (the default setting) allows System Exclusive
messages to be received by the MPX G2.
Options: SysEx Receive Device ID
Press Options to access the SysEx Receive Device ID screen where you can
select 0-126 or All to identify the MPX G2.
Setting this parameter to On will merge data (Program Change, Continuous
Controllers and Note messages) received via the MPX G2 MIDI IN port with the
messages transmitted through the MIDI OUT port. The default for this parameter
is Off.
This control allows you to perform MIDI dumps of Current Pgm, All Programs,
Map 1-3, Chain 1-10, Setup 1-5. Select whichever of these categories you want,
and press Store.
Options: Xmit Speed
Press Options to select one of four MIDI transmission speeds (Slow, Medium
Slow, Medium Fast and Fast.)
NOTE: The Device ID used in dumps is the current Receive Device ID.
SysEx
Press Options to ac-
cess SysEx Receive
Device ID selection. Press
Options again to exit.
Soft Thru
Automation
Press Options to
access Automation
Xmit ID selection. Press
Options again to exit.
To Next Page
Loading...
