5-7
System Controls
MIDI
This menu contains all of the MPX G2 MIDI controls. The operation of each of
these controls is described here. More information on working with MIDI is
presented in Chapter 6.
The Pgm Change control allows you to enable or disable the Reception of MIDI
Program Change messages. The manner in which the MPX G2 interprets these
messages is determined by your selection here.
Off All Program Change and Bank Select messages are ignored. Pgm +
and Pgm - will load the next higher or lower program.
On Program Change messages are recognized.
Options: Pgm# Offset, Pgm+ and Pgm-
Pressing Options from the Pgm Change display allows you to offset MPX G2
program numbers to match another MIDI device.
From Options you can also map Pgm+ and Pgm- controls to load the next
higher or lower program. The following sources can be selected to activate these
controls:
None
Tog 1-3
Sw 1-3
CC 1-119
Select MIDI Channel 1-16, OMNI or Off for receipt of MIDI messages.
Select MIDI Channel 1-16, or Off for transmission of MIDI messages.
Program Change
Press Options to access Pgm+
and Pgm- controls and to set a
program number offset. Press
Options again to return to the
MIDI menu.
Receive
Transmit
Are you sure?
Yes or No
Once you've made changes to the Setup name or selected a new number for
it, press Store again. The display will show:
To store your new Setup, press Yes. To return to the Setup Store display without
saving the Setup, press No.
To Next Page
Loading...
Need help?
General
