4-5
Presets
PCM 81
MODULATION EFFECTS
2.0 FSw2 Elevate ADJUST: Feedback 0–99
Similar to Detuned Ekos, multiple echo voices with diffusion, mod-
ulation and a touch of plate reverb. In this effect, Foot Switch 2 is
patched to turn on the AR Envelope which, in turn, sweeps the
master delay. ADJUST controls the feedback of these rhythmic
echoes.
2.1 Chorus &Pan ADJUST: LFO Rate 0–100
This moving chorus shifts the output signal from left to right, back
and forth. ADJUST sets the speed. Increasing the Delay Master
parameter will smear the delay images.
2.2 Chorus&Amb ADJUST: MstChorus 0–100
Similar to Chorus&Pan but with an added ambience. ADJUST con-
trols the speed and depth of the chorus.
2.3 6 Vox Chorus ADJUST: Less/More 0–50
Starting point for all chorus sounds. ADJUST controls both the cho-
rus depth and speed. Use the Delay Master to open or close the
spacing between the 6 delay voices.
2.4 Split C&E ADJUST: InputPan 0–100
The left input is processed into a lush 3-voice chorus with the voice
panners adjusted from center to left. The right input is processed
into a rhythmic 3-voice echo with the output panned from center
to right. ADJUST cross-pans the inputs. 0 = left/right stereo,
50 = mono, 100 = right/left stereo.
2.5 Env:PanKorus ADJUST: Chorus 0–127
The AR Envelope drives the speed of the pan based on the presence
or absence of input signal. ADJUST varies the chorus amount.
2.6 6 Vox Flange ADJUST: MstrDepth 0–100
A rich stereo flanger with a touch of reverb. ADJUST controls the
flange depth.
2.7 Mod Max ADJUST: Mod Knob 0–50
Multiple parameters all being modulated together. With a stereo
input the LFO drives the input pans to each delay and reverb
processor. A definite "twist your head off" effect. ADJUST controls
several aspects of the modulation.
2.8 PreciseGlide ADJUST: Resonance 0–100
A very clean stereo gliding delay and reverb. ADJUST controls the
resonance of the glide. Soft Row includes master delay and feed-
back parameters so you can add stereo echoes to the effect.
2.9 Round 147 ADJUST: RotorRate 0–20
Big wooden rotary speaker cabinet miked fairly close. ADJUST sets
the speed of the rotors. FX Mix is available in the soft row to con-
trol the amount of reverb relative to the total effect output.
3.0 FSw2 Rotary ADJUST: Width 0–100
A dual-rotor speaker cabinet with a very wide stereo spin and a
touch of ambience. Use ADJUST to control the width and direction
of the spinning rotors. 0= very wide left-to-right, 64 = mono, 127
= very wide right-to-left. Foot Switch 2 is patched to the Latch to
toggle between slow and fast speeds. The AR envelope is used to
simulate the inertial drag as the rotors speed up or slow down.
To Next Page
Loading...
