4-7
Presets
PCM 81
4.2 RoxStutter ADJUST: FX Mix 0–100
Use on those strong rock and roll lead vocals. The trailing echoes
on voices 3 and 4 go longer as the signal disappears. ADJUST
combines the delay effects with a plate reverb effect. Delays 2 and
5 are available in the soft row to add more echo presence.
4.3 Split Pitch? ADJUST: SplitWide 0–127
Modulated varispeed in stereo. One side goes low as the other side
goes high. ADJUST controls the rate and depth of the varispeed.
Good for special FX processing of various sources including synths
and dialog.
4.4 TryTalk’n ADJUST: GldResp 0–100
A variation of Split Pitch? In this version highly colored reverb and
additional delay voices have been added. ADJUST controls the rate
and depth of the varispeed.
4.5 AutoInfinite ADJUST: FX Mix 0–100
With signal present the reverb time runs long. With signal absent
the infinite process is switched on. The threshold for the event is
set high such that after a source is running in the infinite process,
you can play softer passages against it which chorus and echo at
the same time. AR Envelope parameters are included in the soft
row. Adjust the threshold to suit your application.
4.6 Remove Cntr ADJUST: Cntr Fc 0–127
This effect uses filters and crosstalk cancellation to remove mono
material from a stereo mix. ADJUST controls a low pass filter for the
center channel frequencies. As it is turned from 0-127 mono
material is added back into the mix.
4.7 V-Eliminate ADJUST: Cut Zone 0–127
This effect is a vocal eliminater. It is similar to Remove Cntr, in that
it will remove mono material from a stereo mix. In this effect,
however, only frequencies in the vocal range are removed. This
keeps mono low and high frequencies (kick, bass, snare cymbals,
etc.) in the mix. ADJUST controls the width of the elimination
band. Note that phase cancellation will occur if the two outputs are
summed to mono.
4.8 NoCenter Eko ADJUST: Center Fc 0–127
This is the same effect as Remove Center with delays added to the
processed signal. It allows you to add echoes to the left and right
material without affecting the mono material of a stereo mix or sub
mix. For example, you can add additional echoes to a mix without
affecting the vocals, kick or snare. ADJUST controls a low pass filter
for the center channel frequencies.
4.9 Rvb On L–R ADJUST: Decay 0–127
Similar to NoCenterEko, this effect adds dense plate reverb to the
left and right material without affecting the mono material in a
stereo mix. ADJUST controls the mid Rt of the reverberator.
To Next Page
Loading...
